Testing Your Water
You can call (888)623-2324 and arrange a test at your well or send us a water sample and we will do
your test and give you your results at no charge.
We are not a high pressure
sales company, we do not employee sales people, we employ water treatment people that actually care about your water problems and
know how to fix these problems. The products we recommend on this site are the
ones that we have tested, units that we have installed and therefore systems that we
trust. We sell the products we do because they are
the best on the market at the right price. Our products don’t require
the home owner to spend a lot of time doing things to your system or paying
us to do things for your system. Our Motto“YOU SHOULD NOT HAVE TO
THINK ABOUT YOUR WATER!!” means just that. You are to busy living your life
to be adding salt on Saturday or chlorine twice a week or worry about when it
will regenerate. We choose our systems based on “Set and Forget”
We do not sell products
with short warranties. Our warranties are the best in the market. We have
the only 30 day money back guarantee.
“YOU SHOULD NOT HAVE TO
THINK ABOUT YOUR WATER!!”
OUR GOALS SUMMARY
*Service the state of Florida
*Do all we can to be Green
*Provide the best possible
products
*Offer the best possible
prices
*Offer the best possible
service
*Offer the best warranties
More on Water Testing
Sulfate
The Option 1 testing kit includes the sulfate
test, but for sulfur problems the laboratory must be notified to provide a
special container that has a chemical preservative. The testing
kits include the sampling instructions, a questionnaire, and information on
returning the sample. Hydrogen Sulfide- If this is a problem that laboratory
must be told in advance to provide the necessary sampling container with
preservatives.
Since hydrogen sulfide is a gas that is
dissolved in water and can vaporize (escape) from it, laboratory analysis of
hydrogen sulfide in water requires the sample be stabilized immediately
following collection. Since the odor may be caused by a number of factors, it
is critical that the questionnaire be completed and it is highly recommended
that both the Option 1
and Option 3 water testing packages are conducted..
Interpreting Sulfate and
Hydrogen
Sulfide Test Results
Sulfate
The Environmental Protection Agency (EPA)
standards for drinking water fall into two categories -- Primary Standards and
Secondary Standards. Primary Standards are based on health
considerations and are designed to protect people from three classes of toxic
pollutants -- pathogens, radioactive elements and toxic chemicals. Secondary Standards are based on taste, odor, color, corrosivity, foaming and staining properties
of water. Sulfate is classified under the secondary maximum contaminant level
(SMCL) standards. The SMCL for sulfate in drinking water is 250 milligrams per
liter (mg/l), sometimes expressed as 250 parts per million (ppm).
Hydrogen
Sulfide
Although many impurities are regulated by Primary or Secondary Drinking
Water Standards set by the EPA, hydrogen sulfide is not regulated because a
concentration high enough to be a drinking water health hazard also makes the
water unpalatable. The odor of water with as little as 0.5 ppm of hydrogen
sulfide concentration is detectable by most people. Concentrations less than 1
ppm give the water a "musty" or "swampy" odor. A 1-2 ppm
hydrogen sulfide concentration gives water a "rotten egg" odor and
makes the water very corrosive to plumbing. Generally, hydrogen sulfide levels
are less than 10 ppm, but have been reported as high as 50 to 75
ppm.
